Altronix Maximal33R Rack Mount Access Control CCTV fused power supply 12, 24VDC

Altronix Maximal33R Rack Mount Access Control CCTV fused power supply 12, 24VDC
Altronix Maximal33R Rack Mount Access Control CCTV fused power supply 12, 24VDC
Altronix Maximal33R Rack Mount Access Control CCTV fused power supply 12, 24VDC

Altronix Maximal33R Rack Mount Access Control CCTV fused power supply 12, 24VDC

Maximal33R rack mount access power controller distributes and switches power to access control systems and accessories. It converts a 115VAC 50/60Hz input into sixteen (16) independently controlled 12VDC and/or 24VDC fuse protected outputs.

Outputs are activated by an normally open (NO) or normally closed (NC) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. This unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the outputs.

Normally closed [NC] or normally open [NO] dry contact inputs (switch selectable). Power supply 1 / (8) outputs. Power supply 2 / (8) outputs.

Sixteen (16) fuse protected outputs. Maximum current per ACM8R-M output is 2.5A.

Individually selectable Mag Lock/Strike (Fail-Safe, Fail-Secure) solid state fuse protected outputs. Thermal and short circuit protection with auto reset. Latching or Non-Latching fire alarm reset switch individually selectable for each output. Remote reset capability for latching Fire Alarm Interface mode. Fire Alarm disconnect input options.

A Normally open [NO] or normally closed [NC] dry contact input. BPolarity reversal input from FACP signaling circuit. Individual Output Status LEDs located on the front panel. Built-in charger for sealed lead acid or gel type batteries (if batteries are required install separate enclosure). Automatic switch over to stand-by battery when AC fails. Zero voltage drop when unit switches over to battery backup (AC failure condition). AC fail supervision (form "C" contacts).

Notification trigger is selectable for 30 seconds (factory set) or 6 hours. Low battery and battery presence supervision (form "C" contact). Removable terminal blocks with locking screw flange. Illuminated master power disconnect circuit breaker with manual reset.

Operating: 0° C to 49° C (32° F to 120° F). Storage: - 20° C to 70° C (- 4° F to 158° F). Relative Humidity 85% +/- 5%. 12VDC and 24VDC: 106 BTU/Hr. System AC input VA requirement: 437VA. This item is in the category "Business & Industrial\Facility Maintenance & Safety\Access Control Equipment\Locks\Other Locks". The seller is "zsinstruments" and is located in this country: US. This item can be shipped to North, South, or Latin America, all countries in Europe, all countries in continental Asia, Australia.
Altronix Maximal33R Rack Mount Access Control CCTV fused power supply 12, 24VDC